Machine series
Fully electric blow molding machine
Unlike traditional hydraulic systems, this machine relies entirely on electric power, offering heightened precision, energy efficiency, and environmental sustainability.
Machines in this series
Not sure which series fits? Compare blow molding machines by container size and drive type.
What is a fully electric blow molding machine?
A fully electric blow molding machine replaces the hydraulic system with electric servo drives for every movement. With no hydraulic components there is next to no oil contamination at the source, which makes these machines suited to cleanroom production. Tongda’s HSE-12L, for example, is built for 10 mL–50 L containers for medical, food and wet electronic chemical packaging, with an integrated servo wall thickness control system. Its fully electric drives are designed for lower energy use than conventional hydraulic machines.
The HSE II-12L was presented at CHINAPLAS 2024. See the full range of extrusion blow molding machines.
Fully electric models by container size
| Model | Max. container | Stations | Typical products |
|---|---|---|---|
| HSE-5L | 5 L | Single | Medical, food and cosmetic bottles |
| HSE II-5L | 5 L | Double | Higher-output bottle production |
| HSE-12L | 12 L | Single | Cleanroom containers of 10 mL–50 L |
| HSE II-12L | 12 L | Double | Jerry cans and chemical containers |
| HSE-30L | 30 L | Single | Larger clean-grade containers |
When to choose fully electric
- Your containers go to medical, food or electronic chemical customers who require high cleanliness.
- You want the lowest energy use and quiet, precise operation.
- Your products are small and medium containers up to 30 L.
For heavier drums and tanks, compare the servo series. For the lowest investment on standard bottles and jerry cans, see the hydraulic series.
Hydraulic, servo or fully electric?
| Drive | Best suited to | Series |
|---|---|---|
| Hydraulic | Bottles, jerry cans and drums up to 30 L, at the lowest purchase price | Hydraulic machines |
| Servo hydraulic | Medium and large containers from 5 L to 1,200 L, where energy savings are largest | Servo machines |
| Fully electric | Clean, precise production of 10 mL–50 L containers | Fully electric machines |
Applications
Fully electric machines in this series produce daily chemical bottles, milk bottles and jerry cans where cleanliness and precision matter.
Why choose a fully electric blow molding machine over hydraulic?
A fully electric machine has no hydraulic oil, so it suits clean production, uses less energy and repeats movements precisely. A hydraulic machine costs less to buy and covers a wider range of container sizes.
What is the difference between HSE and HSE II?
HSE machines are single station models; HSE II machines are double station models that run two molds for higher output.
Can I see a fully electric machine running?
Yes. Customers are welcome to visit the Tongda factory in Zhangjiagang, Jiangsu, to see machines in production before ordering. You can also watch them running in our video library.
Further reading
A reported double-station line for 600 mL and 700 mL personal-care bottles is the HSEII-12L/8 personal-care bottle case. To compare extra installed cost with measured energy and accepted output, use the all-electric blow molding ROI guide. The whole-machine wall-thickness controller co-developed with Siemens is mainly for all-electric machines. See the parison centering and die-tip FAQ. Factory checks and the payment split for any Tongda machine are on factory acceptance and payment.





