First, start the hollow blow molding machine

1) Turn the hollow blow molding machine clockwise, and turn the main power switch of the single-screw extruder from the horizontal state (OFF state) to the vertical state (ON state).

2) Start the extruder by pressing the green power button on the extruder control panel.

3) Press the blue reset button (R) on the control panel of the blow molding machine.

4) Turn the power switch on the control panel of the blow molding machine clockwise and turn it from the off position (○) to the on position (—).

5) Set the temperature of each part of the extruder barrel on the extruder control panel.

6) Set the temperature of each part of the die on the control panel of the blow molding machine.

7) Set the parameters of each step of the blowing on the touch screen of the blow molding machine.

8) Add material to the funnel of the extruder and screw the funnel to the dosing working position.

9) After all the parts reach the set temperature, wait for about 15 minutes to ensure the temperature is stable.

10) Press the green start button on the extruder control panel to start the screw and rotate the screw speed control knob on the extruder control panel to set the screw speed.

11) Start the motor pump by pressing the green start button on the control panel of the blow molding machine.

12) Turn the mode selector switch on the control panel of the blow molding machine to the fully automatic working mode.

13) After the material flowing out of the die reaches the appropriate length, start the blowing cycle program according to the green start button on the control panel of the blow molding machine.
Second, close the hollow blow molding machine

1) After the blowing cycle program is finished, stop the motor pump by pressing the red stop button on the control panel of the blow molding machine.

2) Screw the extruder hopper to the stop position.

3) After the material in the extruder barrel is squeezed out, rotate the screw speed control knob on the control panel of the extruder to set the rotation speed of the extruder screw to zero. Press the red stop button on the control panel of the extruder. Stop the screw.

4) Turn the power switch on the control panel of the blow molding machine counterclockwise and turn it from the open position (-) to the off position (○).

5) Stop the extruder by pressing the red power button on the extruder control panel.

6) Turn the hollow blow molding machine counterclockwise, and turn the main power switch of the single-screw extruder to the horizontal state (OFF state) from the vertical state (ON state).

Third, matters needing attention

1. Do not use the emergency device (emergency stop button) to stop the device during normal use.